This "American Patriot Blue" Tactical Distancing mask is Police approved and is great for Civilians as well! Stay Safe while perform our duties and tactically distancing. Provided is 1 washable and re-usable mask. 1 nose bridge insert, 2 spunbond polypropylene filters. Masks are shipping daily. Made in the USA. Limit 25
This product is no longer in stock
*IMPORTANT: NOT N95 Certified. The Spunbond Non-woven Polypropylene is the same type of material used in professional protective equipment. Social and Tactical Distancing must still be practiced while wearing this mask
At Hoffners we are proud to be doing our part in this fight against the Covid-19 Coronavirus. We are providing this tough and comfortable mask with filters that are more effective than felt and other recommended materials, so that you can do your job plus you and family can get outside, pick up your supplies, and help keep the American economy moving while staying as safe as possible under these trying conditions.
Law Enforcement approved for use.
The outer shell cloth Mil-spec, Berry compliant, navy blue material.
The mask is washable and should be washed after every use, every day.
The Nose Bridge Contour Strip assures a tight fit around the nose and helps to hold the mask in place.
Made in the USA
The two filters are made of Spunbond Non-woven Polypropylene material. *NOT N95 Certified but the same type of material used in protective masks.
Instructions for use:
Wash hands thoroughly with soap and water for at least 20 seconds before and after handling
Extend the pleats of the mask and Insert the Polypropylene filter into the opening on the inside of the mask, in either direction, flatten it out while distributing it equally over the surface of the mask.
Put the mask with the blue side out over the face covering the bridge of the nose to under the chin.
Wrap the elastic around each ear.
Bend the Nose Bridge Contour Strip around the bridge of the nose to best assure a tight and secure fit.
Maintain at least 6 feet tactical and social distancing.
Remove the used filter from the mask
To clean and disinfect masks and filters gently wash the mask in warm soapy water, using dishwashing liquid. Rinse in clean water and plunge the entire mask body into a disinfection solution of 1/4 cup of nonscented liquid chlorine bleach per gallon of water. Completely submerge mask and filter. Let stand in bleach/water solution for 10 minutes and rinse with fresh water. Air dry. (MCRmedical.com) Wash hands thoroughly with soap and water for a minimum of 20 seconds after handling
**DISCLAIMER: IN RECOGNITION OF THE COVID-19 CRISIS, HOFFNERS IS ONLY SHARING INFORMATION PROVIDED FROM PUBLICLY AVAILABLE RESOURCES. HOFFNERS MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND, EXPRESS OR IMPLIED ABOUT THE EFFICACY, COMPLETENESS, ACCURACY, RELIABILITY, SAFETY OR SUITABILITY WITH RESPECT TO THE INFORMATION SHARED HERE. THE USE OF SPECIFIC METHODOLOGIES OR TECHNOLOGIES TO DECONTAMINATE PPE OR FFP MATERIALS HAS NOT BEEN SCIENTIFICALLY EVALUATED BY HOFFNERS. THE DECISION TO USE ANY METHOD FOR THE USE OF AND APPLICATION OF PPE OR FFR DECONTAMINATION SHOULD BE DONE SO ONLY AT THE SOLE DISCRETION OF QUALIFIED MEDICAL PERSONNEL. INFORMATION CONTAINED HERE DOES NOT REPRESENT MEDICAL ADVICE NOR IS IT A SUBSTITUTE FOR REGULATORY GUIDANCE AND/OR REQUIREMENTS. USE OF THIS INFORMATION IS AT YOUR SOLE RISK.